Introduction to Commissioning of Cence Bench Type Low Speed Centrifuge
Commissioning of Cence desktop high-speed and low-speed centrifuges: PLEASE remember NOT to start the machine before checking the centrifuge chamber and taking out items other than the rotor, otherwise the machine may be damaged.
Please follow the operation steps. Before starting the machine, first confirm whether the rotor of the centrifuge is loose. If there is no abnormality, the centrifuge will be operated under no load. First the maximum speed is set to 1000r/min. After starting the machine and when the speed reaches to 1000r/min, set the maximum speed to 2000r/min. When the speed runs to 2000r/min, add 1000r/min successively until the maximum speed supported by the rotor of the machine is reached.
After completion, add the maximum load, and confirm whether the rotor is loose before startup. If the horizontal rotor is used, press the hanging bucket by hand to see if there is bucket jamming. If there is no abnormality, start the operation. The maximum speed is set to 1000r/min. After the machine is started and operated to 1000r/min, set the maximum speed to 2000r/min. When the speed is operated to 2000r/min, 1000r/min is successively added until the maximum speed supported by the rotor of the machine is reached. If there is no exception, the debugging is successful.
Contact Person: Miss. Zhou